Resolutions-1997-021

2. If two driveways per lot are desired, two driveways with minimum dimensions of twenty-four (24) feet measured at the street side of the sidewalk and thirty-two (32) feet at the curb line will be allowed. 3. If the single frontage length is greater than or equal to one hundred and fifty (150) feet, two driveways with maximum dimensions of thirty-four (34) feet measured at the street side of the sidewalk and forty-two (42) feet at the curb line will be allowed. B. Corner Lots (Figure 3.5) 1. On corner lots, driveways shall be constructed as far away from the intersection as possible and still remain upon the property. In no case shall there be less than twenty (20) feet between the end of the radius of a street intersection and the beginning of a driveway curb cut as measured at the curb line. 2. In no instance shall more than three driveways be allowed on a double frontage property with no more than two on any single frontage. 3. One driveway per frontage with maximum dimensions of thirty-four (34) feet measured at the street side of the sidewalk and forty-two (42) feet at the curb line will be allowed. 4. If one frontage length is greater than or equal to one hundred and fifty (150) feet, two driveways with maximum dimensions of thirty-four (34) feet measured at the street side of the sidewalk and forty-two (42) feet at the curb line will be allowed on the longer frontage. 3.10 STATE HIGHWAY AND INDUSTRIAL AREAS (NON-RESIDENTIAL) (Figure 3.6) A. Type A drives are for high traffic volume, joint or common property driveways requiring protection for left turn movements. Type A drives shall be 45 feet wide at the property or sidewalk line. This width contains one 16-foot lane in a 4-foot painted or raised median and two 12-foot lanes out. B. Type B drives are for high traffic volume, joint or common property driveways. Type B drives shall be 41 feet wide at the property or sidewalk line. This width contains one 16-foot lane in and two 12-foot lanes out. C. Type C drives are for lower volume single property driveways. Type C drives shall be 28 feet wide at the property or sidewalk line this width contains one 14-foot lane in and one 14-foot lane out. 3.11 DOUBLE FRONTAGE LOTS – FRONT AND BACK A. Each frontage of lots with frontage on two parallel streets shall comply with the applicable standards for single frontage lots contained in Sections 3.07, 3.08, and 3.09. B. Some subdivisions may prohibit access onto the higher classification street. Check the subdivider's agreement and the City of Tiffin Access Regulation Ordinance in each case.