Ordinances-1995-197

completed within a period of two (2) years from the date of approval of such final plat; but such approval of the plat shall not constitute final acceptance of any improvements to be constructed. Improvements will be accepted only after their construction has been completed. 5.13 Requirement of the Final Plat: The subdivider shall, within one (1) year from the date of approval of the preliminary plat, unless such time period has been extended, prepare and file with the City Clerk, twenty (20) copies of the final plat and required attachments, as set forth in this ordinance. Except for a final plat for a minor subdivision as set forth herein, no final plat shall be considered by the Governing Body until and unless a preliminary plat for the area included in the proposed final plat has been approved and has not expired and become void as set forth above. The final plat shall be drawn at a scale of one inch equals one hundred feet (1" = 100') or larger. Sheet size shall be no greater than eighteen inches by twenty-four inches (18" x 24") nor smaller than eight and one-half inches by eleven inches (8-1/2" x 11"). and shall be of a size acceptable to the County Auditor. If more than one sheet is used, each sheet shall clearly show the number of the sheet, the total number of sheets included in the plat, and match lines indicating where other sheets adjoin. The final plat shall be clearly marked "Final Plat" and shall show the following: A) The name of the subdivision. B) Name and address of the owner and subdivider. C) Scale, and a graphic bar scale, north arrow and date on each sheet. D) All monuments to be of record, as required by Chapter 355, Code of Iowa. E) Sufficient survey data to positively describe the bounds of every lot, block, street, easement, or other area