other · C
Discussion and Review of Tiffin Municipal Code Revisions – Preparation for Setting the Public Hearing — Tiffin City Code - DRAFT
Dated September 15, 2026City Council — work session, September 15, 2026 718 pages
Ord. 1983-117, Ord. 2018-437, Ord. 2010-302, Ord. 2012-309, Ord. 2007-288, Ord. 2012-313, Ord. 2007-287, Ord. 2018-433, Ord. 2019-446, Ord. 2012-319, Ord. 69
Page 276 of 718
Text from the PDF text layer; check the PDF for anything that matters.CHAPTER 135 STREET USE AND MAINTENANCE
135.13 INSTALLATION OR REPLACEMENT OF CULVERTS.
1. Application. City property owners must apply, in writing, for permission to
install any new culverts or replace any existing culverts. Said application must be
accompanied by a drawing that shows: (i) the proposed new or replacement culvert’s
dimensions, including diameter and length; (ii) its location to any affected property
lines; (iii) its location to the edge of any street pavements; and (iv) any other
information the City Engineer or Public Works Director may request. Applications
submitted without said drawing will be automatically denied.
2. Requirements. All new and replacement culverts:
A. Must have a minimum diameter of 12 inches.
B. Must be constructed of either 2000D strength reinforced concrete pipe
(RCP) or 10-gauge corrugated metal pipe (CMP).
3. Approval. All applications for new or replacement culverts will be either
approved or denied, in writing, by the City Engineer. The City Engineer shall have
the right to request a larger diameter culvert, a longer culvert, or any variations in the
proposed bury depth, cover material, or alignment of culverts.
4. Installation Notification. The Public Works Director must be notified 24
hours in advance of any installation of a culvert. The Public Works Director may, at
their discretion, determine if an on-site inspection will be required.
5. Violations. If a culvert is replaced or installed without approval, found to be
constructed of any unapproved material, or fails to meet any request of the City
Engineer, it shall be removed by the City. The costs incurred by the City to remove
any culvert shall be assessed to the property owner who is determined by the City to
be in violation of this chapter.
6. Liability. No City personnel, including the City Engineer or Public Works
Director, will install or replace any culvert on private property. The City will not be
responsible for the procurement of any contractors or suppliers. Property owners will
be liable for any damages to ditches, street surfaces, sidewalks, municipal utilities,
private utilities, and neighboring properties.
[The next page is 1129]
CODE OF ORDINANCES, TIFFIN, IOWA
- 1124 -
Sources
- revize: Tiffin City Code - DRAFT (gFbbE0YR86eHDItZtXhZZqxLfknUlz.pdf) — where it was found ↗ first seen Oct 12, 2026
Attached to agenda item: C Discussion and Review of Tiffin Municipal Code Revisions – Preparation for Setting the...
Data last updated October 18, 2026. Built from the archive's documents; see how the data is built.