§ 4.10 Nonresidential Subdivisions

The following provisions shall apply to nonresidential subdivisions:

A) General. If a proposed subdivision includes land that is used for commercial or industrial purpose, the layout of the subdivision with respect to such land may be subject to additional provisions as the City Council may require. A nonresidential subdivision shall be subject to all the requirements of these regulations, as well as such additional standards required by the City Council, and shall conform to the proposed land use and standards established in City plans and regulations. Sidewalks and landscaping plans must be submitted for approval.

B) Standards. In addition to the principles and standards in these regulations, which are appropriate to the planning of all subdivisions, the subdivider shall demonstrate to the satisfaction of the City that the street, parcel, and block pattern proposed is specifically adapted to the uses anticipated and takes into account other uses in the vicinity. The following principles and standards shall be observed:

1) Proposed industrial or commercial parcels shall comply with the zoning ordinance.

2) Street rights-of-way width and pavement thickness shall be adequate to accommodate the type and volume of traffic anticipated to be generated thereupon.

3) Special requirements may be imposed by the City with respect to the installation of public utilities, including water, sewer, and storm water drainage.

4) Every effort shall be made to protect adjacent residential areas from potential nuisance from a proposed commercial or industrial subdivision, including the provision of extra depth in parcels backing up on existing or potential residential development and provisions for a permanently landscaped buffer strip when necessary.

5) Streets carrying nonresidential traffic, especially truck traffic, shall not normally be extended to the boundaries of adjacent existing or potential residential areas.

ARTICLE V: PROCEDURES AND SUBMISSION REQUIREMENTS FOR PLATS

Amended by 2012-319