city code

2019 Design Standards Amendments

25 pages Ord. 2012-313

Open the PDF Searchable (OCR) PDF

Page 17 of 25

Text from the PDF text layer; check the PDF for anything that matters.
2. Matching Existing Walks a. The width and location of a new sidewalk shall match the width and location of existing sidewalks in the area. However, the sidewalk width shall not be less than 5 feet (no tapers allowed). b. Sidewalk cross slope may be varied through a gradual transition to match existing adjoining walks. Contact City Hall if existing adjoining walks vary significantly from existing standards. Chapter 13 Traffic Signals No amendments Chapter 14 Trenchless Construction No amendments Chapter 15 Miscellaneous No amendments Chapter 16 Fencing Add the following as Chapter 16 Fencing: 16A-1 A. Fencing Requirements 1. At the time of approval of the final plat, the Subdivider of any subdivision which has a boundary abutting land used for agricultural purposes shall agree to be responsible for the construction and maintenance of all fences between the subdivision and all land used for agricultural purposes. A required fence shall consist of either: a. Not less than 26 inches of substantial woven wire on the bottom with three strands of barbed wire with not less than 36 barbs of at least 2 points to the rod on top; the top wire to be not less than 48 inches, nor more than 54 inches high; or b. Good substantial woven wire of not less than 48 inches nor more than 54 inches high, with one barbed wire of not less than 36 barbs of 2 points to the rod, nor more than four inches above said woven wire. These fence construction standards shall be considered the minimum standard to be required by agreements pursuant to this article. 2. The Subdivider shall satisfy the following conditions regarding fences: a. At the time of submittal of the final plat, the Subdivider shall submit a Subdivider’s Agreement with the City that sets forth provisions for fence agreements with the owners of property adjoining the land included in the final plat. The fence agreement will specify the responsible party of fence construction and maintenance. b. Required fence agreements shall at a minimum, contain the following: 1.) A statement that the agreement shall be binding on both parties, their heirs, and assigns. 2.) A statement that the agreement shall run with the land. 3.) A termination clause effective upon the subdivision of the adjoining property for non- agricultural purposes. 3. Prior to approval of the final plat, the subdivider shall submit copies of the recorded fence agreements with the owners of property adjoining the final plat. Where the owner of property adjoining the plat shall fail to enter into said fence agreement the City of Tiffin may nevertheless approve the final plat after the following condition has been satisfied: 17

Sources

  • citycode: 2019 Design Standards Amendments (2019-Design-Standards-Amendments.pdf) — where it was found ↗ first seen Oct 12, 2026

This document's details as JSON

Data last updated October 16, 2026. Built from the archive's documents; see how the data is built.