ordinance
Ordinances-1995-197
Page 24 of 40
Text read by the vision model; check the PDF for anything that matters.Front - 35 feet
Interior side yard - 15 feet
Corner side yard - 25 feet
Rear yard - 25 feet
J) Reversed frontage lots are prohibited. Double frontage lots shall only be permitted where abutting a major street and a minor street, and such lots shall front only on the minor street.
4.08 Parks and Open Space:
All residential subdivisions should be so designed as to meet the neighborhood park and open space needs of their residents. The following standards and procedures will be used to determine the park and open space requirements for all proposed residential developments or subdivisions greater than 1/2 acre in size within the City of Tiffin:
A) For all residential developments and subdivisions, the subdivider shall be responsible for providing adequate park and open space in one or both of the following ways, depending on the decision of the City of Tiffin.
1) If it is feasible and compatible with the Community Development Plan of the City of Tiffin, as determined by the City Council upon the recommendation of the Planning And Zoning Commission, the subdivider will be required to dedicate and reserve an area for parks and open space, without cost to the City.
a) The amount of land shall be determined by first calculating the entire size of the land area of the proposed development as shown on the preliminary plat or site plan and then to require dedication or reservation of five percent (5%) of this amount for parks and open space.
b) This area shall be denoted on the final plat prior to approval of the final plat.
2) Where such dedication is not feasible or compatible with the Community Development Plan, as determined by the City Council upon recommendation of the Planning and Zoning Commission, the subdivider shall, in
Sources
- laserfiche: Ordinances-1995-197 (Ordinances-1995-197.pdf) — where it was found ↗ first seen Oct 12, 2026
Data last updated October 16, 2026. Built from the archive's documents; see how the data is built.