ordinance
Ordinances-1995-197
Page 21 of 40
Text read by the vision model; check the PDF for anything that matters.5) Sidewalk ramps. All sidewalks shall provide a curb ramp for accommodation of the handicapped at all intersections. Curb ramps shall be located in line with the public sidewalk. Curb ramps shall comply with all requirements for said ramps as set forth in the "Americans With Disabilities Act." Ramps shall be sloped from the sidewalk intersection to the curb.
H) Driveways. The following standards shall apply to residential driveways:
1) A single driveway shall be twelve (12) feet in width at street.
2) A double driveway shall be twenty-four (24) feet in width at the street.
3) Residential driveways shall be 6" thick nonreinforced Portland Cement Concrete with the same strength and mix requirements as the adjoining street.
4.07 Block and Lot Standards:
The following standards shall apply to the layout of blocks and lots in all subdivisions:
A) No residential block shall be longer than thirteen hundred (1,300) feet or shorter than three hundred (300) feet measured from street line to street line. The width of blocks should be arranged so as to allow two tiers of lots, with utility easement.
B) In blocks over seven hundred (700) feet in length, the Governing Body may require a public way or an easement at least ten (10) feet in width, at or near the center of the block, for use by pedestrians.
C) The size and shape of lots intended for commercial or industrial use shall be adequate to provide for the use intended, and to meet the parking, loading, and other requirements for such uses contained in the zoning ordinance (see 4.07 (e) below).
Sources
- laserfiche: Ordinances-1995-197 (Ordinances-1995-197.pdf) — where it was found ↗ first seen Oct 12, 2026
Data last updated October 16, 2026. Built from the archive's documents; see how the data is built.