Packet: Tiffin City Council Work Session (09/15/2026)
packet
Document 281
Dated September 15, 2026City Council — work session, September 15, 2026 730 pages
Ordinance 1983-117, Ordinance 2018-437, Ordinance 2010-302, Ordinance 2012-309, Ordinance 2007-288, Ordinance 2012-313, Ordinance 2007-287, Ordinance 2018-433, Ordinance 2019-446, Ordinance 2012-319, Ordinance 69
Open the PDF (opens in a new tab) Searchable PDF (opens in a new tab)
Packet: Tiffin City Council Work Session (09/15/2026), Page 537 of 730
Text from the PDF text layer; check the PDF for anything that matters.CHAPTER 166 ESTABLISHMENT OF ZONING DISTRICTS AND THE OFFICIAL ZONING MAP
the decibel limits in the octave bands in Section
166.16(14)(K)(1)(c)(v).
(2) Vibration.
a. Any commercial operation or activity that must cause
at any time and at any point along the nearest adjacent lot
line, earth borne vibrations in excess of the limits set forth
in Column I of the following Tables (d) and (e) is prohibited.
b. Any commercial operation or activity that must cause
at any time and at any point along a residential district
boundary line, earth borne vibrations in excess of the limits
set forth in Column II of the following Tables is prohibited.
c. Exceptions. The following uses and activities shall
be exempt from the vibration level regulations:
i. Vibrations not directly under the control of
the property user.
ii. Vibrations emanating from construction and
maintenance activities between 7:00 a.m. and 9:00
p.m. Such activities are those that are non-routine
operations accessory to the primary activities and that
are temporary in nature or conducted infrequently.
iii. Transient vibrations of moving sources such
as automobiles, trucks, airplanes, and railroads.
iv. Vibrations must be expressed as
displacement in inches and must be measured with a
three-component measuring system approved by the
Zoning Administrator.
d. Maximum Permitted Steady-State Vibration
Displacement Level.
Steady-State
Vibration Steady-State
Frequency DisplacementA (in.) DisplacementA (in.)
(Cycles per second) (Maximum Adjacent (Maximum Adjacent
Commercial and Residential Uses)
Industrial Uses)
0-9 0.0008 0.0004
10-19 0.0005 0.0002
20-29 0.0003 0.0001
30-39 0.0002 0.0001
40-over 0.0001 0.0001
A
Steady-State vibrations, for purposes of this Code, are vibrations
that are continuous, or vibrations in discrete impulses more
frequent than 100 per minute. Discrete impulses that do not exceed
100 per minute, shall be considered impact vibrations, and shall not
cause in excess of twice the displacement stipulated.
CODE OF ORDINANCES, TIFFIN, IOWA
- 1641 -
Sources
- City agenda center (revize): Agenda packet (packet_2026-09-15_3ae8c189-9979-4d30-987b-38d0c38bde62.pdf) — where it was found first seen Oct 12, 2026
Data last updated November 11, 2026. Built from the archive's documents; see how the data is built.