other · C
Discussion and Review of Tiffin Municipal Code Revisions – Preparation for Setting the Public Hearing — Tiffin City Code - DRAFT
Document 280
Dated September 15, 2026City Council — work session, September 15, 2026 718 pages
Ord. 1983-117, Ord. 2018-437, Ord. 2010-302, Ord. 2012-309, Ord. 2007-288, Ord. 2012-313, Ord. 2007-287, Ord. 2018-433, Ord. 2019-446, Ord. 2012-319, Ord. 69
Page 550 of 718
Text from the PDF text layer; check the PDF for anything that matters.CHAPTER 166 ESTABLISHMENT OF ZONING DISTRICTS AND THE OFFICIAL ZONING MAP
a. Smoke Emission. In the C-3 District, the emission of
more than 12 smoke units per stack in any one hour period is
prohibited. However, once during any six-hour period each
stack shall be permitted up to 12 additional units in a 15-
minute period for soot blowing and fire cleaning. Only
during such 15-minute periods shall smoke of a density or
equivalent opacity equal to, but not exceeding, Ringelmann
Chart No. 3 be permitted, and then only for fire cleaning and
for not more than four minutes per period.
b. Particulate Matter. The rate of emission of
particulate matter from all sources within the boundaries of
any lot shall not exceed the rate established in the following
chart:
Maximum Permitted Particulate Matter Emission Rate
Height of Emissions Pounds per Hour
(ft) (per Acre)
0-49 1.00
50-99 1.01
100-149 1.06
150-199 1.10
200-299 1.16
300-399 1.30
400-over 1.50
c. Method of Measurement.
i. Smoke. To grade the density or equivalent
opacity of emission of smoke, the Ringelmann Chart
shall be employed. To determine smoke units, the
Ringelmann reading shall be made at least every
minute during the period of observation. Each
reading (Ringelmann number) shall be multiplied by
the time in minutes for which it is observed, and the
products added together to determine the total
number of smoke units observed during the total
period of observation.
ii. Particulate Matter. The total net rate of
emission of particulate matter within the boundaries
of any lot must be determined as follows: Determine
the maximum emission in pounds per hour from each
source of emission and divide this figure by the
number of acres of lot area, thereby obtaining the
hourly rate of emission in pounds per acre. Add
together the individual rate of emission as derived
above to obtain the total rate of emission from all
sources of emission within the boundaries of the lot.
This total shall not exceed the rate established in the
table in Section 166.18(14)(K)(3)(b).
CODE OF ORDINANCES, TIFFIN, IOWA
- 1674 -
Sources
- revize: Tiffin City Code - DRAFT (gFbbE0YR86eHDItZtXhZZqxLfknUlz.pdf) — where it was found ↗ first seen Oct 12, 2026
Attached to agenda item: C Discussion and Review of Tiffin Municipal Code Revisions – Preparation for Setting the...
Data last updated October 22, 2026. Built from the archive's documents; see how the data is built.